Amorphization and graphitization of single-crystal diamond - A transmission electron microscopy study

The amorphization and graphitization of single-crystal diamond by ion implantation were explored using transmission electron microscopy (TEM). The effect of ion implantation and annealing on the microstructure was studied in (100) diamond substrates Si⁺ implanted at 1 MeV. At a dose of 1 × 10¹⁵ cm^{- 2,} implants done at 77 K showed a damage layer that evolves into amorphous pockets upon annealing at 1350 °C for 24 h whereas room temperature implants (303 K) recovered to the original defect free state upon annealing. Increasing the dose to 7 × 10¹⁵ Si⁺/cm² at 303 K created an amorphous-carbon layer 570 ± 20 nm thick. Using a buried marker layer, it was possible to determine that the swelling associated with the amorphization process was 150 nm. From this it was calculated that the layer while obviously less dense than crystalline diamond was still 15% more dense than graphite. Electron diffraction is consistent with the as-implanted structure consisting of amorphous carbon. Upon annealing, further swelling occurs, and full graphitization is achieved between 1 and 24 h at 1350 °C as determined by both the density and electron diffraction analysis. No solid phase epitaxial recrystallization of diamond is observed. The graphite showed a preferred crystal orientation with the (002)g//(022)d. Comparison with Monte Carlo simulations suggests the critical displacement threshold for amorphization of diamond is approximately 6 ± 2 × 10²² vacancies/cm³.